Reliability of measuring tools?

Worth mentioning but don't fit in other categories.
Post Reply
LesForgue
Posts: 140
Joined: Mon Sep 12, 2011 6:29 pm
Type of boat I like: JEM Trapper by Matt
Location: Chicago
Contact:

Reliability of measuring tools?

Post by LesForgue » Thu Jun 21, 2012 3:39 pm

I got a big aluminum square from Menard's or Home Depot (forget which), and while I was working on drawing panel cut lines onto my plywood, I realized that so and so many inches on that thing does not match that measurement on my old steel square and several other rulers.
I had a bit of erasing to do becasue of the inconsistency.

If you can't trust a ruler, well, I don't know,
Anybody else experienced such?

Or, Maybe the square that seems off is actually a state of the art instrument, adjusted for the curvature of the earth?

tx river rat
Posts: 988
Joined: Wed Feb 21, 2007 10:48 pm
Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
Location: Tx

Re: Reliability of measuring tools?

Post by tx river rat » Thu Jun 21, 2012 5:47 pm

An old timer taught me the first thing you did with a new framing
was to square it, he did the squaring with a center punch .
not sure about the markings maybe its in tenths or mm
Ron

neon14
Posts: 181
Joined: Tue Jul 13, 2010 8:19 pm
Type of boat I like: SUP hybrid kayak
Location: Center Point, Tx

Re: Reliability of measuring tools?

Post by neon14 » Sun Jul 01, 2012 9:34 pm

Had that problem before. I have came to the conclusion that nothing is square.

lilmoe
Posts: 24
Joined: Wed Jun 17, 2009 12:36 pm
Type of boat I like: buccaneer

Re: Reliability of measuring tools?

Post by lilmoe » Mon Jul 02, 2012 6:11 am

I was taught to always check a new square by putting against a straight edge, mark along the edge, then flop it side to side, and check your mark. Most of them will not be perfect, but can be adjusted with a punch to be the same. A level should also be checked, but sometomes you just have to go with It looks right.

Post Reply