Page 1 of 1

First project on the lathe

Posted: Sun Sep 30, 2012 11:16 am
by neon14
Finally got to fiddle around with Dads new lathe. Was trying to figure out something simple to build that would be useful. So I made a shifter knob for my truck. I got to use a lot of different set ups. Faced and turned, couple of center drills, drilled, tapped, knurled, and used the part off tool. Didn't get picks of every step but here are a few.

Image
Image
used a center drill to chamfer the hole before tapping
Image

Here is a video of the knurling process. I think my feed rate was a little slow but it still came out pretty good
http://www.youtube.com/watch?v=5m7dOoErVmQ

Image
Image
Looks like its floating above the grand canyon! My mouse pad turned out to be a good place to take a pic of this thing :D

Re: First project on the lathe

Posted: Sun Sep 30, 2012 2:46 pm
by jem
Now that's a nice play room that has those kind of toys!