JEM Watercraft
http://www.jemwatercraft.com/forum/

How bout this?
http://www.jemwatercraft.com/forum/viewtopic.php?f=17&t=2825
Page 6 of 7

Author:  jem [ Sun Nov 22, 2009 7:27 pm ]
Post subject:  Re: How bout this?

Uncle John's has a set of nice little chair plans designed by our own Oldsparkey.

Author:  Yohan1973 [ Sun Nov 22, 2009 7:46 pm ]
Post subject:  Re: How bout this?

jem wrote:
Uncle John's has a set of nice little chair plans designed by our own Oldsparkey.

Is this it?
Image
http://www.unclejohns.com/boat/seat/default.htm

Author:  jem [ Sun Nov 22, 2009 8:32 pm ]
Post subject:  Re: How bout this?

yes

Author:  jbo_c [ Thu Nov 26, 2009 11:43 am ]
Post subject:  Re: How bout this?

Looks perfect. I'm definitely on board to pick up the plans. It'll be second on my build list, though. I'm in mid move right now, so I'm not getting any building done until the house sells.

Jbo

Author:  jem [ Sat Nov 28, 2009 10:10 am ]
Post subject:  Re: How bout this?

Drawings are complete. Assembly instructions are left to do.

Author:  Oldsparkey [ Sat Nov 28, 2009 10:39 am ]
Post subject:  Re: How bout this?

About the chair...... You could get one from these folks http://www.rockymountaindecor.com/produ ... -or-cherry It has a flat seat and I don't think it would be as comfortable as the one I dreamed up. Plus mine can be made from scrap wood or if you purchase the wood a lot less then the ones they have. But with theirs at $219.00 and on sale for $179.00 you do save $40.00 :lol: :lol: :lol:

If you make the chair to go with the boat Matt is designing , take some of the epoxy form making the boat and put a coat of it on the chair ( or two coats if you want to ) if it gets wet , no big deal.
A small piece of felt or rubber on the feet of the chair keeps it from sliding around... Contact cement works really good to put the non skid material on the feet of it.

Chuck.

Author:  Yohan1973 [ Sat Nov 28, 2009 9:01 pm ]
Post subject:  Re: How bout this?

jem wrote:
Drawings are complete. Assembly instructions are left to do.

HOT DANG! good news!
P.S.
Thanks for the info Oldsparkey.

Author:  jbo_c [ Sat Nov 28, 2009 11:14 pm ]
Post subject:  Re: How bout this?

Can you pull this one out of two sheets or will it take three?

Jbo

Author:  olsnappa [ Sun Nov 29, 2009 3:00 am ]
Post subject:  Re: How bout this?

jem wrote:
Drawings are complete. Assembly instructions are left to do.

:D :D :D :D

Author:  jem [ Sun Nov 29, 2009 8:48 am ]
Post subject:  Re: How bout this?

jbo_c wrote:
Can you pull this one out of two sheets or will it take three?

Jbo


4...well like 3-1/2.

Page 6 of 7 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/