not completely straight lines
not completely straight lines
Got all the boards our for the lake 14, andmy cuts are not completely straight. Presumable the stitch and glue method and these plans allow for this? As long as shape is consistent and i am okay with my QA measurements should i be okay? Also, how important is sanding the edges if I am going to be fileting them and covering with fiberglass?
-
- Site Admin
- Posts: 4915
- Joined: Fri Jun 18, 2004 8:14 pm
- Type of boat I like: Wooden
- Location: Greensboro, NC
- Contact:
Re: not completely straight lines
Stack like panels together and sand the edges to help clean up the waviness.
Long as you don't waves over ~4mm you should be ok.
Long as you don't waves over ~4mm you should be ok.
-Matt. Designer.
Re: not completely straight lines
Okay, perfect. I should be okay. Nothing off by 4mm.