how to convert (connect) sander exhaust to vacuum cleaner

Ask your questions here. Guests welcome to post!
Post Reply
mango2
Posts: 1
Joined: Sun Sep 18, 2011 5:18 pm
Type of boat I like: 10 foot garvey...

how to convert (connect) sander exhaust to vacuum cleaner

Post by mango2 » Sat Sep 24, 2011 1:53 pm

what have builders done to their sanders exhaust to allow a vacuum cleaner to directly suck up the dust particles when sanding? What and where would I go to obtain materials to adapt my hand-held palm sander? thanks much for all your assistance before attempting to build my stitch and glue boat........

User avatar
PiratePete
Posts: 304
Joined: Fri Sep 11, 2009 6:57 am
Type of boat I like: Wadefish + Mirarge Drive.
Location: Tassie, Australia

Re: how to convert (connect) sander exhaust to vacuum cleane

Post by PiratePete » Sat Sep 24, 2011 6:11 pm

My sander came with a small dust bag to collect the dust. I just had to remove it & poke the vacuum pipe onto the spigot the bag fitted to.

I did make up an extra cyclone to fit between the sander & the vacuum to stop most of the dust actually getting into the vacuum.

Here is what I did

viewtopic.php?f=8&t=3190&start=19

Its a 20Kg grease drum, a 4L paint tin some shade cloth & a few wireties & silicon.

Only the very finest dust now makes it into the vacuum.

Post Reply