JEM Watercraft

scuppering inner gunwales
Page 1 of 1

Author:  LesForgue [ Fri Sep 26, 2014 10:33 am ]
Post subject:  scuppering inner gunwales

For my JEM Trapper canoe I'm looking at a scuppered inner gunwale.
Instead of cutting out blockks or discs and glueing them by the sheer inside the hull and then gueing a long strip over the blocks, wondering about first setting 2 long strips side by side and drilling vertical holes to end up with half-circle vertical holes in each strip and then just glueing those on for the inner gunnels.


Any comments or pros/cons would be appreciated Thanks


Author:  jem [ Sat Sep 27, 2014 6:41 am ]
Post subject:  Re: scuppering inner gunwales

That would work and would bend easier.

The scuppered gunwale look actually comes from mounting gunwales over ribs of canvas canoes.

Author:  LesForgue [ Mon Sep 29, 2014 9:49 am ]
Post subject:  Re: scuppering inner gunwales

Thanks for the confirmation Matt.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group