Cleat location and Front temp frame SABALO 15'
Posted: Fri Dec 11, 2015 3:49 am
Matt,
1. Page 13 of 38 refers --- top of page 13...point 2 at top of page --- FORWARD TANK WELL cleat location?? ---Quote..refer to the T-cleat location drawing. Glue the cleats below the lines shown...unquote--On which page is the cleat location detailed??
2. Page 11 of 38 refers---the page shows a graphic of the FRONT TEMP FRAME...this is understood as a lineup for hull panels...on 19 point 13 and 14 the assembly mentions stitch panels C and B.....understood and the TEMP FRAME is still there to assist in alignment----page 35 refers point 29---stitch panel A to frames---TEMP FRAME STILL IN PLACE as per drawing. Page 36 ---point 30-install floors---and the sketch still shows the TEMP FRAME in place and from there forward there is no mention of removing the FRONT TEMP FRAME. Could please clarify Matt...does this TEMP FRAME remain and become an integral part of the construction or at which point of overall assembly is the TEMP FRONT FRAME REMOVED??
JIG for drilling stitch holes. Page 15 mentions 12" spaced holes for Sabolo Kayak and then on page 17 it is mentioned 6-8" holes...----Which spacing is is recommended.????---- My gut feeling is 6" for more accuracy during panel alignment.
Thats it.....Thanks Matt.
Ian S.
1. Page 13 of 38 refers --- top of page 13...point 2 at top of page --- FORWARD TANK WELL cleat location?? ---Quote..refer to the T-cleat location drawing. Glue the cleats below the lines shown...unquote--On which page is the cleat location detailed??
2. Page 11 of 38 refers---the page shows a graphic of the FRONT TEMP FRAME...this is understood as a lineup for hull panels...on 19 point 13 and 14 the assembly mentions stitch panels C and B.....understood and the TEMP FRAME is still there to assist in alignment----page 35 refers point 29---stitch panel A to frames---TEMP FRAME STILL IN PLACE as per drawing. Page 36 ---point 30-install floors---and the sketch still shows the TEMP FRAME in place and from there forward there is no mention of removing the FRONT TEMP FRAME. Could please clarify Matt...does this TEMP FRAME remain and become an integral part of the construction or at which point of overall assembly is the TEMP FRONT FRAME REMOVED??
JIG for drilling stitch holes. Page 15 mentions 12" spaced holes for Sabolo Kayak and then on page 17 it is mentioned 6-8" holes...----Which spacing is is recommended.????---- My gut feeling is 6" for more accuracy during panel alignment.
Thats it.....Thanks Matt.
Ian S.