JEM Watercraft
http://www.jemwatercraft.com/forum/

Transom and temp front frame
http://www.jemwatercraft.com/forum/viewtopic.php?f=5&t=4034
Page 1 of 1

Author:  IanS [ Tue Jan 05, 2016 12:40 am ]
Post subject:  Transom and temp front frame

Matt,

Where or how do I find accurate transom and temp frames dimensions? Kinda thought the main frame would suffice but seems the profile and dimensions differ. Transom I could pencil out after the hull is stitched and glassed. But the main temp frame and the small frame frame (I dont have drawings with me as I write this from the only internet connection on the island)--thus mention a smaller temp frame.... and have searched for temp frame dimensions and at a loss. :?

Please advise. So far all is cool....parts cut, epoxy sourced in Manila...just the temp frame etc and I can start assembly process.

Thanks Matt. Happy New year and much success for 2016.

Ian S

Author:  jem [ Fri Jan 08, 2016 6:18 pm ]
Post subject:  Re: Transom and temp front frame

IanS wrote:
Matt,

Where or how do I find accurate transom and temp frames dimensions? Kinda thought the main frame would suffice but seems the profile and dimensions differ. Transom I could pencil out after the hull is stitched and glassed. But the main temp frame and the small frame frame (I dont have drawings with me as I write this from the only internet connection on the island)--thus mention a smaller temp frame.... and have searched for temp frame dimensions and at a loss. :?

Please advise. So far all is cool....parts cut, epoxy sourced in Manila...just the temp frame etc and I can start assembly process.

Thanks Matt. Happy New year and much success for 2016.

Ian S


I answered in the other forum post you made but I'll repeat: It's in the 11x17 drawing packet. Drawing labeled "misc"

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/