JEM Watercraft
http://www.jemwatercraft.com/forum/

frame for sabalo 15
http://www.jemwatercraft.com/forum/viewtopic.php?f=5&t=4037
Page 1 of 1

Author:  jonico [ Sat Mar 26, 2016 11:29 am ]
Post subject:  frame for sabalo 15

Hello,
anyone knows the size of the central panel which used goanywhere. I refer to what I said at the end of the cockpit to make ice/fish box between the cockpit and tankwell
I would do the same thing for my sabalo 15.
thank you and sorry for writing errors
edoardo

Author:  jem [ Wed Mar 30, 2016 6:02 am ]
Post subject:  Re: frame for sabalo 15

This is a frame on the plans?

Author:  jonico [ Wed Mar 30, 2016 1:56 pm ]
Post subject:  Re: frame for sabalo 15

Hello Jem and thanks for the reply. I'm sorry, but i do not understand.
this is not on the plans. in the plans we have two temp frame forward cockpit and one for the tankwell.
I refer to the frame to be installed at the end of the frame cockpit near tankwell

Author:  jem [ Sat Apr 02, 2016 10:18 am ]
Post subject:  Re: frame for sabalo 15

If you email me at info@jemwatercraft.com I'll send you a drawing of a frame tht can fit right behind the cockpit to create a seale compartment.

Author:  jonico [ Sat Apr 02, 2016 3:21 pm ]
Post subject:  Re: frame for sabalo 15

ok. thanks, jem

Author:  OnkaBob [ Mon Apr 11, 2016 6:44 am ]
Post subject:  Re: frame for sabalo 15

Matt, I'm not certain but I think Edoardo is interested in copying the cockpit / ice box built into the Sabalo built by member Goanywhere as shown on the page in the link below.

viewtopic.php?f=8&t=3426&start=130

Edoardo, is this what you are asking about?

Author:  jonico [ Sun May 22, 2016 11:38 am ]
Post subject:  Re: frame for sabalo 15

Sorry.
I intend to fiberglassing before the inner hull completely. cutting for the mirage drive must be done before or after?
thank you

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/