JEM Watercraft
http://www.jemwatercraft.com/forum/

Step 1: Drawing and Cutting the Panels
http://www.jemwatercraft.com/forum/viewtopic.php?f=6&t=26
Page 1 of 1

Author:  jem [ Thu Sep 02, 2004 1:10 pm ]
Post subject:  Step 1: Drawing and Cutting the Panels

Tools needed: tape measure, square, your drawing, and pencil.
Image

Draw the references lines and offsets. Example:
Image

Draw the curves by marking the offset points and using a flexible piece of material like PVC tubing. Bend the tubing and hold in place so it interesects each point. Draw your curve.
Image

Your result will be:
Image

JEM Watercraft plans provide a method to check your work to ensure you've drawn them correctly: Measure twice, cut once.
Image

Cut out you panels:
Image

Tip: If you have mirrored imaged panels, draw and cut the 1st panel, then use it as a template for the other panel.
Image

Sand the edges (Tip: if you have mirrored panels, lay them on top of each other and sand at the same time):
Image

Repeat for all panels.
Image

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/