|roller cover from pipe insulation
|Page 1 of 1|
|Author:||LesForgue [ Thu Feb 08, 2018 3:35 pm ]|
|Post subject:||roller cover from pipe insulation|
I used pipe insulation tubing, cut to size, for roller covers.
Their inside diameter was small for my roller, so I cut a lengthwise piece to fill the gap.
They do not absorb much epoxy.
|Author:||oldbuffpilot [ Sun Feb 11, 2018 12:51 am ]|
|Post subject:||Re: roller cover from pipe insulation|
Thanks, I'll give it a try.
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group