JEM Watercraft
http://www.jemwatercraft.com/forum/

Tolerances
http://www.jemwatercraft.com/forum/viewtopic.php?f=7&t=71
Page 3 of 3

Author:  Wannabe [ Sun Jun 08, 2014 9:15 am ]
Post subject:  Re: Tolerances

So Ron,
Does that mean that people who post on these forums don't give a whatever about what the Gubmt. thinks. :wink:
Bob

Author:  tx river rat [ Sun Jun 08, 2014 1:16 pm ]
Post subject:  Re: Tolerances

Bob
Maybe it is because we are so innocent and pure :lol: :lol:
Ron

Author:  Wannabe [ Sun Jun 08, 2014 1:21 pm ]
Post subject:  Re: Tolerances

Wannabe wrote:
So Ron,
Does that mean that people who post on these forums don't give a whatever about what the Gubmt. thinks. :wink:
Bob

:roll: :wink:

Author:  jem [ Sun Jun 08, 2014 5:41 pm ]
Post subject:  Re: Tolerances

Gaps are required on larger power boats. The gap filled with epoxy works like cartilage between your bones to evenly absorb and disperse pressure and stress from planing. Just as bone-on-bone is painful, it's bad for the long term health of a stitch and glue power boat.

These smaller canoes and kayaks don't come anywhere close to absorbing those kinds of forces. So an inconsistent gap is ok. But an even gap does look nice.

As for the forum being slow, well that's probably on me. I need to put more in to talk about. Life pretty busy in our house these past few years. Doesn't look to slow down soon. But never say never.

Author:  Oldsparkey [ Sun Jun 08, 2014 9:07 pm ]
Post subject:  Re: Tolerances

jem wrote:
As for the forum being slow, well that's probably on me. I need to put more in to talk about. Life pretty busy in our house these past few years. Doesn't look to slow down soon. But never say never.


Matt......
Things are quiet all over , mine is normally busy with a lot of ( non Boat building ) chatter but for the last 4 or 5 months things have quieted down.
Heck one member posted and asked if anyone was out there or did his computer die. :lol:

Chuck.

Page 3 of 3 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/