JEM Watercraft

JEM Watercraft

Customer Service Forum
Direct Links To: Canoe Plans  --  Kayak Plans  --  Other Plans
It is currently Sun Mar 18, 2018 9:21 pm

All times are UTC - 5 hours [ DST ]

Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Simple Way to Measure Epoxy
PostPosted: Wed Jul 19, 2006 7:54 pm 
Site Admin
User avatar

Joined: Fri Jun 18, 2004 8:14 pm
Posts: 4856
Location: Greensboro, NC
Epoxy is made of 2 parts: Resin and Hardener.

Most epoxies call for a 2:1, 3:1, or 5:1 ratio of Resin and Hardener. One way to measure the appropriate amount to use metering dispensing pumps that are offered by many suppliers.

These pumps typically are very reliable but they do break down after a while and let air into the pump. This causes the pump to "burb" and give an inaccurate amount of Resin or Hardener. So if you don't have reliable metering pumps or want to use a more visual method, here's an easy method.

Helping in the demonstration is our 8-year old assitant who happens to be the "E" in JEM (JEM Watercraft). :D

Please note: This method shows how to mix a small amount of epoxy with a 2:1 Resin-to-Hardener ratio. This can be adjusted for more epoxy or different ratios.

You'll need some clear plastic cups and a permanent marker.


Place one cup inside another.


Decide how much total epoxy you want to mix at one time. In this example, we selected about 1/2 of the plastic cup.

With the marker, draw a line on the outer cup. Label it "H" for Hardener.

For a 2:1 ratio, you have 3 total parts: 1 part Hardener and 2 parts Resin. So we marked our line about 1/3 up toward half the cup. If your epoxy is 3:1, then you'll have 4 total parts. Mark about 1/4 the way up.

In this next part, we use water. Much cheaper and easier to clean up if you make a mistake.

With an empty cup still inside the marked cup, fill to the marked line.


Remove the inner cup and set aside. Measure 2 more parts so you have a total of 3 equal parts.


Place a cup back inside the marked cup, and pour the 3 equal parts into the cup.


Mark another line on the cup and label it "R" for Resin.


So when your ready to mix, first fill the inner cup with Hardener up to line H, then fill with Resin to line R. Remove the inner cup and mix. Save the marked cup for the next batch.

Easy! :D

-Matt. Designer.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Template made by DEVPPL/ThatBigForum