Frame Reference Lines for trapper - Pickle

Builder show and discuss their progress.
Post Reply
ralphobarly
Posts: 16
Joined: Sun Feb 28, 2010 10:02 am
Type of boat I like: Trapper designs

Frame Reference Lines for trapper - Pickle

Post by ralphobarly »

Hello all,

I'm building a trapper. I've currently stitched 4 panels together ( the bottom 2 then one more on each side) I'm at the stage where I have to insert the frames to stitch it to the proper shape. However, I have just noticed now that I have gotten myself into a pickle. The frames are to be stitched onto "reference lines" which I have since sanded off. What I'm wondering is if I could get a measurement from bow/stern of where the reference lines are supposed to be for the trapper 35 frames?

Thanks

Matthew
jem
Site Admin
Posts: 4915
Joined: Fri Jun 18, 2004 8:14 pm
Type of boat I like: Wooden
Location: Greensboro, NC
Contact:

Re: Frame Reference Lines for trapper - Pickle

Post by jem »

26" [660] and 70" [1778] from the bow tip.
-Matt. Designer.
ralphobarly
Posts: 16
Joined: Sun Feb 28, 2010 10:02 am
Type of boat I like: Trapper designs

Re: Frame Reference Lines for trapper - Pickle

Post by ralphobarly »

Thanks Matt! Is that also the same from the stern?

Thanks again

Matthew
jem
Site Admin
Posts: 4915
Joined: Fri Jun 18, 2004 8:14 pm
Type of boat I like: Wooden
Location: Greensboro, NC
Contact:

Re: Frame Reference Lines for trapper - Pickle

Post by jem »

Same for both ends. :)
-Matt. Designer.
Post Reply