JEM Watercraft
http://www.jemwatercraft.com/forum/

non-skid varnish surface
http://www.jemwatercraft.com/forum/viewtopic.php?f=8&t=3939
Page 1 of 1

Author:  stripper [ Wed Jan 22, 2014 11:59 am ]
Post subject:  non-skid varnish surface

I have built a Northwind stripper--started a year ago and am finally varnishing. This is my first boat and Matt warned me when I was first inquiring that it would be a hard one to build as a first project. He was right. But I do now have a boat that I think will be quite fast and seaworthy.

Anyway, does anyone have experience putting a non-skid surface on the floor? I read that you can mix sugar or salt into the varnish. Sounds messy and maybe pretty rough.

Author:  Oldsparkey [ Wed Jan 22, 2014 2:37 pm ]
Post subject:  Re: non-skid varnish surface

I don't like to use Sugar or the Salt and just use some fine builders sand and you do not need a lot of it. Or just get some Non Slid products from the paint store , they should have a selection of it you your use.

Chuck.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/