I'm sure this is covered somewhere, but I couldn't find it.
I'm about to re-coat the hull on the wife's Freedom 15.
Everything is sanded, but I'm wondering if I should wipe it down with a chemical wash to insure a good bond between the old epoxy & the new?
Lee
re-coating an old finish
-
- Posts: 220
- Joined: Tue May 08, 2007 10:31 am
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: Cedar Rapids, Iowa
re-coating an old finish
There are three kinds of people in this world.
Those who can do math, and those who can't.
Those who can do math, and those who can't.
-
- Site Admin
- Posts: 4915
- Joined: Fri Jun 18, 2004 8:14 pm
- Type of boat I like: Wooden
- Location: Greensboro, NC
- Contact:
Re: re-coating an old finish
A light scrub with acetone wouldn't hurt. But sanding should have taken care of things.
-Matt. Designer.
-
- Posts: 220
- Joined: Tue May 08, 2007 10:31 am
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: Cedar Rapids, Iowa
Re: re-coating an old finish
Thanks Matt.
There are three kinds of people in this world.
Those who can do math, and those who can't.
Those who can do math, and those who can't.