Finally got to fiddle around with Dads new lathe. Was trying to figure out something simple to build that would be useful. So I made a shifter knob for my truck. I got to use a lot of different set ups. Faced and turned, couple of center drills, drilled, tapped, knurled, and used the part off tool. Didn't get picks of every step but here are a few.
used a center drill to chamfer the hole before tapping
Here is a video of the knurling process. I think my feed rate was a little slow but it still came out pretty good
http://www.youtube.com/watch?v=5m7dOoErVmQ
Looks like its floating above the grand canyon! My mouse pad turned out to be a good place to take a pic of this thing
First project on the lathe
-
- Site Admin
- Posts: 4916
- Joined: Fri Jun 18, 2004 8:14 pm
- Type of boat I like: Wooden
- Location: Greensboro, NC
- Contact:
Re: First project on the lathe
Now that's a nice play room that has those kind of toys!
-Matt. Designer.