Page 1 of 2
12' Garvey flex
Posted: Sun Jan 09, 2005 3:48 am
by Boatplans.dk
Hello Builders,
The plans for the new 12’ dingy is ready for purchase. It is called 12’ Garvey flex so it became a new boat in the Garvey flex series. The plans are set at a introduction price for a short period. Hope you will enjoy the new design. The full description of the 12’ Garvey flex can be seen here
www.boatplans.dk/mo-gf12.asp
I am looking for someone to build the first boat. For the project I will supply the plans, epoxy, fibre glass and filler needed for the building and in return you will have to sent me pictures of the building and the finished boat. If you are interested in participating in this project, please sent me an email with a introduction and some references.
garvey flex build
Posted: Wed Jan 12, 2005 10:44 am
by dorymate
Plans look great, should be a good build and a versatile boat.Thanks again.
Posted: Mon Jan 17, 2005 12:00 pm
by jem
Hey Builders,
Pass the word about this one. Here's what Morten is looking to do:
He will send you the plans at
NO CHARGE.
You loft and cut out the panels and send him pictures.
He will then send you the epoxy, fiberglass, and woodflour at
NO CHARGE. you get them
for free!
Then you build and send him pictures. The only thing you pay for is plywood, the motor, and the paint and you have yourself a nice boat. He gets the benefits of having pictures of the boat built. That's a great deal!
builder yet?
Posted: Sat Jan 22, 2005 9:28 am
by Skylane182
Did you find a builder yet? I have a gamefisher 9.9hp that needs a home,,,If I can talk the "boss" (wife) into another project?...hee hee
Re: builder yet?
Posted: Sat Jan 22, 2005 10:12 am
by jem
Skylane182 wrote:Did you find a builder yet? I have a gamefisher 9.9hp that needs a home,,,If I can talk the "boss" (wife) into another project?...hee hee
Send Morten an e-mail! Will only cost you plywood, paint, and some time.
Test builder
Posted: Tue Mar 01, 2005 1:44 am
by Boatplans.dk
I have found a test builder for the 12' Garvey flex. Thanks to all of you that applied for the job.
Posted: Thu Mar 03, 2005 11:50 pm
by banoe
Morten, Can you stretch the Garvey flex. to 15'? I got a 20hp long shaft out board in the shed that needs a home.
Posted: Fri Mar 04, 2005 12:02 am
by Boatplans.dk
Something like this?
It is 14' but relatively wider than the 12'. It will cary a 20 hp outboard.
Posted: Tue Mar 08, 2005 9:45 pm
by Guest
Morten some questions
Could you remove center seats and put in plywood floor with ribs?
Make the front seat larger for standing and fishing?
How wide is the boat.
How much plywood and epoxie would it use.
Posted: Tue Mar 08, 2005 11:29 pm
by Boatplans.dk
The boat can be build with 9 sheets of plywood. I haven’t calculated the amount of epoxy yet.
The boat is 1,622 m or 5’4”.
It would be possible to extend the forward seat abaft. Then leave out the two seats at the centre and then having a floor instead. The frames will still be needed. It will just demand more plywood and epoxy.