Posted: Wed Jun 25, 2008 7:05 am
coming along nicely! 
tankwell stitched and tacked
cockpit fitted to frame
filleted
Bare hull I'm thinking I'll fillet chines, do end pours and glass inside before cleaning up the outside
Page 3 of 10
Posted: Sun Jun 29, 2008 6:10 am
Bit more progress
tankwell stitched and tacked
cockpit fitted to frame
filleted
Bare hull I'm thinking I'll fillet chines, do end pours and glass inside before cleaning up the outside
tankwell stitched and tackedcockpit fitted to framefilletedBare hull I'm thinking I'll fillet chines, do end pours and glass inside before cleaning up the outside
Posted: Sun Jun 29, 2008 11:54 am
Bemm,
I', likely asking a dumb question here, but - will you use an outboard on that tall transom?
I', likely asking a dumb question here, but - will you use an outboard on that tall transom?
Posted: Sun Jun 29, 2008 1:40 pm
Jack, there's another panel that needs to be installed. That transom is only about 10" high.
Posted: Sun Jun 29, 2008 9:21 pm
Your not the first to ask that Jack........They think it will have an electric.but the transom is quiet small as Matt says.
I'd prefer something with more grunt ...
Like a "GO DEVIL"mud drive
How many H.P. you recon she'll handle Matt
I'd prefer something with more grunt
...Like a "GO DEVIL"mud drive
How many H.P. you recon she'll handle Matt
Posted: Sun Jun 29, 2008 9:33 pm
Posted: Mon Jun 30, 2008 4:21 am
Little by little
tankwell filleted
bow endpour fillet
stern endpour
I'll let everything sit for a few days then sand and fiberglass t/well c/pit and inside hull........sanding
tankwell filleted
bow endpour fillet
stern endpour
I'll let everything sit for a few days then sand and fiberglass t/well c/pit and inside hull........sanding
Posted: Sun Jul 20, 2008 4:05 pm
Some more progress shots 
Posted: Wed Jul 30, 2008 4:00 am
Did a bit on my footbrace recesses
when I've completed the filleting I'll tape the outside fillets and then glass inside of cockpit with some graphics maybe.... tried some experiments printing on tissue paper under glass (tankwell underside)
when I've completed the filleting I'll tape the outside fillets and then glass inside of cockpit with some graphics maybe.... tried some experiments printing on tissue paper under glass (tankwell underside)
Posted: Wed Jul 30, 2008 2:36 pm
I like your recessed foot braces - boat's coming along extremely well... and fast!