Step 1: Drawing and Cutting the Panels

Step by step example of how to build a boat using the stitch and glue method.
Locked
jem
Site Admin
Posts: 4915
Joined: Fri Jun 18, 2004 8:14 pm
Type of boat I like: Wooden
Location: Greensboro, NC
Contact:

Step 1: Drawing and Cutting the Panels

Post by jem »

Tools needed: tape measure, square, your drawing, and pencil.
Image

Draw the references lines and offsets. Example:
Image

Draw the curves by marking the offset points and using a flexible piece of material like PVC tubing. Bend the tubing and hold in place so it interesects each point. Draw your curve.
Image

Your result will be:
Image

JEM Watercraft plans provide a method to check your work to ensure you've drawn them correctly: Measure twice, cut once.
Image

Cut out you panels:
Image

Tip: If you have mirrored imaged panels, draw and cut the 1st panel, then use it as a template for the other panel.
Image

Sand the edges (Tip: if you have mirrored panels, lay them on top of each other and sand at the same time):
Image

Repeat for all panels.
Image
-Matt. Designer.
Locked