Dk canoe ply wood thickness

Forum for Guests welcome to post!
Post Reply
Posts: 5
Joined: Wed Apr 14, 2010 4:23 pm
Type of boat I like: DK touring canoe

Dk canoe ply wood thickness

Post by spencer66 »

Have been through the plans a few tines and cut out all parts .have used 7 mm construction ply as I have loads available at no cost> cant work out with the stich method has the mid panels sitting on top of the bottom panel or do they meet at a point or do the sides fit over the bottom ending flush with the outside bottom? I have even wondered if I should 45 degree bevel the edges of the bottom and mid panel where they meet. Am I being to fussy do I just sew the thing together and hope for the best? First time canoe builder and loving it!!!HELP PLEASE
Site Admin
Posts: 4914
Joined: Fri Jun 18, 2004 8:14 pm
Type of boat I like: Wooden
Location: Greensboro, NC

Re: Dk canoe ply wood thickness

Post by jem »

they are intended to meet on the edges and form a natural channel for the epoxy-glue.
-Matt. Designer.
Post Reply