Hi i have been thinking for some time now on building 2 laker 13s one for me and one for my daughter.
She is as keen on fishing as i am and she would like to go offshore so i thought why not make the two lakers
so they can be joined together and form a catamaran with a small centre "deck"/work bench,
The yolk at the rear could also be designed to take a small out board motor
any thoughts on this would be greatly appreciated
Regards. Cridgie down under
lakers "joined at the hip"
-
- Posts: 205
- Joined: Tue Jan 05, 2010 8:56 pm
- Type of boat I like: Okwata kayak
- Location: South Coast NSW Australia
Re: lakers "joined at the hip"
This sounds like it could make a nice stable fishing platform for smooth waters. Similar to the pontoon boat in Matts free plans But with the advantage of two detachable Kayaks. In interesting concept.
Roger
Roger
Okwata LC,
Northwind,
Quetico
Northwind,
Quetico
-
- Posts: 374
- Joined: Wed Mar 30, 2011 7:20 am
- Type of boat I like: Fishing SOTs.
- Location: Adelaide, South Australia.
Re: lakers "joined at the hip"
Certainly workable. You need to make sure that the attachment points are strong, pontoon boats are subject to very strong forces if waves cause twisting of the two boats. If used on fairly flat water you should have no problems.
My psychologist reckons I need lots of fishin' therapy!
-
- Site Admin
- Posts: 4915
- Joined: Fri Jun 18, 2004 8:14 pm
- Type of boat I like: Wooden
- Location: Greensboro, NC
- Contact:
Re: lakers "joined at the hip"
a couple of simple mounting brackets on the deck of each boat on you should have it. I'll try to draw a sample sketch later today.
-Matt. Designer.
-
- Posts: 90
- Joined: Sun Jul 27, 2008 6:57 am
Re: lakers "joined at the hip"
Thanks Matt i would appreciate that
cridgie down under
cridgie down under
-
- Site Admin
- Posts: 4915
- Joined: Fri Jun 18, 2004 8:14 pm
- Type of boat I like: Wooden
- Location: Greensboro, NC
- Contact:
Re: lakers "joined at the hip"
You could install something on the deck to pin a joining beam between the hulls.
Words of caution:
1) You have to do front and back, 2 beams for strength. One is not enough as the hull is designed. You'll rip the deck off with only one beam.
2) This set up is for calm water only.
3) Be sure you mount near the under deck supports.
4) The beam should be 1" thick by 2" tall and made from laminated wood (like 2 layers of 1/2" ply)
Words of caution:
1) You have to do front and back, 2 beams for strength. One is not enough as the hull is designed. You'll rip the deck off with only one beam.
2) This set up is for calm water only.
3) Be sure you mount near the under deck supports.
4) The beam should be 1" thick by 2" tall and made from laminated wood (like 2 layers of 1/2" ply)
-Matt. Designer.