Page 1 of 1
new Laker 13 in Sth Australia
Posted: Tue Oct 22, 2019 1:18 am
by build_it
I'm finishing a Laker 13 I had cut out panels for in 2008 but life, the universe and 16 shades of crap stopped me from going further.Last Friday I restarted the project by covering the panels with west system. I now have the hull ready for filleting so things are happening again at a reasonable pace and its starting to look like a kayak.
Cheers for now
Pete
Re: new Laker 13 in Sth Australia
Posted: Tue Oct 22, 2019 5:41 am
by jem
like fine, aged wine...
Re: new Laker 13 in Sth Australia
Posted: Wed Oct 23, 2019 1:54 am
by build_it
yep the ply is perfectly seasoned now.
Pete
Re: new Laker 13 in Sth Australia
Posted: Fri Oct 25, 2019 2:23 am
by build_it
And now the inside fillets are done. Time to turn it over tomorrow and continue the process.
Re: new Laker 13 in Sth Australia
Posted: Fri Nov 01, 2019 12:47 am
by build_it
Today I put fibreglass tape on the inside seams of the deck halves.I'll do the other sides tomorrow and maybe the hull as well weather permitting
Its hot and a hot dusty wind making working on the boat miserable so called it a day. now relaxing under the a/c with a cool beverage next to me.
Pete
Re: new Laker 13 in Sth Australia
Posted: Wed Nov 13, 2019 12:08 am
by build_it
Today I finished taping the outside seams. Tomorrow I hope to get started on painting the insides and the under deck bits then hopefully placing the deck in position and getting it ready for gluing into place.
Pete
Re: new Laker 13 in Sth Australia
Posted: Sun Nov 17, 2019 11:57 am
by oldbuffpilot
It's good to know there's someone out there building
Re: new Laker 13 in Sth Australia
Posted: Sun Nov 17, 2019 10:19 pm
by build_it
only way to get the boat design you want thats not plastic.
Pete