Got some damage to repair, first want all to be DRY.

Ask your questions here. Guests welcome to post!
Post Reply
LesForgue
Posts: 197
Joined: Mon Sep 12, 2011 6:29 pm
Type of boat I like: JEM Trapper by Matt
Location: Chicago
Contact:

Got some damage to repair, first want all to be DRY.

Post by LesForgue »

Trapper 15_38. Lots of gravelly launches and landings. Now there's bottom damage at the very narrow part of one end.
The damage goes into the plywood.
I have what I need to repair the deep gash,
but I'm concerned about the repair entrapping some water in there.
How long should I let the canoe dry?
How could I be sure all the water is gone before I close the wound?
Thanks.
Les
Les Richard Forgue
Cowbro
Posts: 22
Joined: Thu Apr 23, 2020 11:58 pm
Type of boat I like: Blue fin

Re: Got some damage to repair, first want all to be DRY.

Post by Cowbro »

https://www.harborfreight.com/digital-m ... 67143.html

Harbor Freight sells a cheap moisture meter. if you want to take a reading and compare to some comparable material, perhaps a scrap left over from the boat.

Did the boat sit submerged for an extended period of time? if it is was only used occasionally and dried out in between then i would probably just sand the area thoroughly and prep as needed for the repair. If you are really worried, perhaps a day or two to bake outside in the sun?
LesForgue
Posts: 197
Joined: Mon Sep 12, 2011 6:29 pm
Type of boat I like: JEM Trapper by Matt
Location: Chicago
Contact:

Re: Got some damage to repair, first want all to be DRY.

Post by LesForgue »

Thanks for the advice
Les Richard Forgue
Post Reply